Boring zippers no more! Grab a slice! It's chessylicious!
Items you need:
- 2 x “4mm x 30cm” paracord.
- *4 x “3mm (diameter) x 2mm (thick)” magnets (neodymium magnets are recommended for better holding power).
- Super glue (for the magnets).
*If you do not have magnets, I have included a 3D-printed Connector.
Suggested print settings:
- Layer height 0.2mm.
- Infill 30%.
- Position the print in a way that the joining face is facing downwards.
- No supports are needed.
NOTE Most of our designs are printed and tested on a Prusa Mini and MK4, so tolerances may vary if you are using a different brand. While we strive for a smooth experience with our designs, we appreciate your understanding if tolerance issues arise.
This work is licensed under a Creative Commons (4.0 International License) Attribution—Noncommercial—Share Alike
Categories:
3 Likes3 DownloadsNovember 1, 2024
3 Likes3 DownloadsNovember 1, 2024