The basic plan that gives you access to files for personal use!
5 downloads per month

Simple as that.

Basic Personal

These files were made by me, and are for a prop replica with a barrel that rotates, and hammers that move, when the trigger is pulled. The prop consists of 19 printed pieces, as well as 4 bearings (2x2 different sizes), and a few springs. This purchase is only the files, no physical objects are included. There are two barrel files, one with names and one without. The Hammer and Grip files need to be printed once as is, and once mirrored along their flat faces.

Inside the zipped folder is a read me txt file that has a link to the youtube video that goes through the build and best practices for printing. For best results you will need both resin and fdm prints.

2x skateboard bearings (size 608, bore of 8mm)

2x larger bearings (bore of 25mm, exterior diameter of 37mm, thickness 7mm)

2 tension springs, and 1 compression spring.

The purchase of this file is for personal use only and does not entitle printing for commercial purposes. Commercial licensing is available through my Patreon.

Demonstration and build video:
https://youtu.be/bfflWnVsAww

The List - Percy's Pepperbox from The Legend of Vox Machina

Rear Retainer.STL

Trigger.STL

Barrel (Clear).STL

Barrel (Named).STL

Barrel Tube.STL

Body Insert.STL

Body Left.STL

Body Right.STL

Central Axle.STL

Front Retainer.STL

Grip.stl

Hammer Axle.STL

Hammer Catch.STL

Hammer.STL

Hand.STL

LeafSpring.STL

Ratchet Stop.STL

Ratchet.STL

A dragon skull that drips smoke from the nose from backflow incense cones. Looks great as it develops colour from the incense over time, accentuating the sculpted form. The skull is roughly 25cm (9.8") long, fits vertically on a bambu X1Carbon. Displayed model was printed in PLA with tree supports. Support blocker used in the tunnel in the nose to keep it open/clear.

******Designed to use a ceramic insulator that the incense sits in, so that the plastic does not melt/deform over time. They can be found on Amazon here: https://shorturl.at/iFlcR

Suggested you use a clear coat spray paint to seal the model so that the incense oils don't wick into the layers over time. A couple layers on the outside as well as a couple short sprays into the top hole, then holding it with the nose pointing down for a minute or two to seal in inside of the tunnel.

**Burning incense poses a risk of fire, as well as producing particulate that may cause harm. Heated plastics may off-gas and can cause harm from continual exposure. Never leave burning incense unattended, as plastic is also flammable and can lead to property damage or injury.

Dragon Skull Incense Burner

DragonSkull_IncenseBurner.stl

Prop building, toy inventing, hobby collecting, and everything in between.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

wessels.creations

Achievements

Seedling