A dragon skull that drips smoke from the nose from backflow incense cones. Looks great as it develops colour from the incense over time, accentuating the sculpted form. The skull is roughly 25cm (9.8") long, fits vertically on a bambu X1Carbon. Displayed model was printed in PLA with tree supports. Support blocker used in the tunnel in the nose to keep it open/clear.
******Designed to use a ceramic insulator that the incense sits in, so that the plastic does not melt/deform over time. They can be found on Amazon here: https://shorturl.at/iFlcR
Suggested you use a clear coat spray paint to seal the model so that the incense oils don't wick into the layers over time. A couple layers on the outside as well as a couple short sprays into the top hole, then holding it with the nose pointing down for a minute or two to seal in inside of the tunnel.
**Burning incense poses a risk of fire, as well as producing particulate that may cause harm. Heated plastics may off-gas and can cause harm from continual exposure. Never leave burning incense unattended, as plastic is also flammable and can lead to property damage or injury.
