My Cura Vase settings

: LAYER HEIGHT .2 : INITIAL LAYER LINE WIDTH 110% : WALL THICKNESS 3 : WALL LINE COUNT 7 :BOTTOM THICKNESS 3 : BOTTOM LAYERS 15 :INITIAL BOTTOM LAYERS SAME AS ABOVE :OPTIMIZE WALL PRINTING ORDER CHECK : OUTER BEFORE INNER WALLS CHECK :COMPENSATE WALL OVERLAPS CHECK :FILTER OUT TINY GAPS AND PRINT THIN WALL CHECK :INFILL DENSITY 0% :PRINT TEMP 205 :PRINT TEMP INITIAL LAYER 210 :INITIAL PRINT TEMP 205 : FINAL PRINT TEMP 200 : BUILD PLATE TEMP 60 :PRINT SPEED 50 :ENABLE RETRACTION CHECK :RETRACT AT LAYER CHANGE CHECK

IM USUING A BMG EXTRUDER MY RETRACTION MAY BE DIFFERNT YOU WILL HAVE TO FIGURE YOUR RETRACTION SPEEDS

PRETTY MUCH THATS IT OTHER THAN YOUR NORMAL SETTINGS

HOPE THIS HELPS