GOOD 3D OBJECT TO ORGANIZE YOUR WALL CHARGERS

.2 LAYER HEIGHT
WALL LINE COUNT 2
INFILL 15%
SPEED 60M/S

LETTERS!!!!!
.2 LAYER HEIGHT
WALL LINE COUNT 3
INFILL 35%
SPEED 60M/S

WALL CD v0.stl

WCDT v0.stl

hammer

.2 layer height
60 mm/ sec
4 wall line count
60% infill
supports (yes)


V3D HAMMER v2.stl

My Cura Vase settings

: LAYER HEIGHT .2
: INITIAL LAYER LINE WIDTH 110%
: WALL THICKNESS 3
: WALL LINE COUNT 7
:BOTTOM THICKNESS 3
: BOTTOM LAYERS 15
:INITIAL BOTTOM LAYERS SAME AS ABOVE
:OPTIMIZE WALL PRINTING ORDER CHECK
: OUTER BEFORE INNER WALLS CHECK
:COMPENSATE WALL OVERLAPS CHECK
:FILTER OUT TINY GAPS AND PRINT THIN WALL CHECK
:INFILL DENSITY 0%
:PRINT TEMP 205
:PRINT TEMP INITIAL LAYER 210
:INITIAL PRINT TEMP 205
: FINAL PRINT TEMP 200
: BUILD PLATE TEMP 60
:PRINT SPEED 50
:ENABLE RETRACTION CHECK
:RETRACT AT LAYER CHANGE CHECK

IM USUING A BMG EXTRUDER MY RETRACTION MAY BE DIFFERNT YOU WILL HAVE TO FIGURE YOUR RETRACTION SPEEDS

PRETTY MUCH THATS IT OTHER THAN YOUR NORMAL SETTINGS 

HOPE THIS HELPS



Spiral_Vase.stl

in slicer program orientate part flat this will allow you to change different colors as needed for this part, you will need supports under the flag section. NOTE!!!!!! people have made metal extensions to put these in the ground for extended height (metal tube) you can buy at lowes ect

Yard Markers

8.5 FLAG 10 YD 1.stl

punch to help break off supports if needed

cura settings
layer height .2
shell (wall line count)=8
infill density 40%
i used red pla plus
machine cr6se

punch v1.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow