Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3092441.

this is a minimalist soap holder.  it is high enuff to keep soap dry.

no supports needed.

soap dish min

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4702242.

i made this gage to make it easy to set the focusing the laser of the neje master to 30watt laser that i have. 

it is in mm.  in 1 mm increments.  with numbers in 5 mm increments.

its neat cuz once the laser module is loose and set the red plastic bottom of the module at the top (40mm) of the gage and pull the gage out the module falls down the next steps following the gage.   allowing you to view at the same time the laser dot.  easy to compare right away the different focus diameters to pick the best exact  one.   its almost automatic.  and its super fast to set the focus.  you dont have to set it each step as you would with the ortur where you have to turn the focus lens each time.

you import the dxf into your laser software.  or you can print it out once you extrude it for your 3d printer if you like.

it might be useful for other laser cutters/engravers.


neje laser focus gage

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3020450.

a low ploy chibii cat

chibii cat

pulr.stl

Switch Guard

Switch_Guard2 Solid

tinkerbell

holder for the edge of a 1 inch table to hold  micro sd cards, sd cards, usbs, and usb cables.

multi msd-sd-usb holder

usbh5sdh.stl

i made this baby groot hollow to use less filament.
it looks printable with no supports and 0% infill
use supports only at the back door which holds the led.
with no infill but with 3 inner and outer and top shells.

baby groot hollow

baby_groot_sit_hollow_2.stl

a simple belt buckle design i came up with to print and wear.

use supports. but so little supports i doubt you need any.

print obj file no need to separate until after printed. the parts come apart easy.

buckle 

buckle rnd bbr m

i took this idea from vise grips. it locks down nicely.

this is print in place.

i printed it on its side, but it might print set on bottom.

needs supports.

vise grip chip clip

vise gripx2 v1 Component2 lever (1)

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

vegveg1988

Achievements

Sequoia

Fan Favorite

Explorer