So i got a flip 3, nice little phone, bit more faster than the pixel 5 and guess what... it bends in half.... no way.... So feeling rather like a 1980's Shatner right here, looking like a total knob asking hte wife to beem me up scotty, its a tad on the slippery side naked (the phone not me), kinda like tryin to hold a sea bass fillet whilst havin your hand dipped in grease.
that said, most of the cases both suck and blow at the same time, too fat, too flimsy, so i designed one. Printing in PLA works like a charm, carbon fibre too brittle, trying nylon pla for laughs cause im a masochist.
You will need a little double sided tape to stop the case slipping off over time, all the flip cases have this anyways.
Best to print these flat side up with support, its a lot of support sure but you get a nice finish on the top side instead of the impressions of your bed. Added little snap off parts to stop warping on ends.
Happy days people, print no faster than 60mms people cause she canny take it any more captain!