tracking pixel
Troy M

Solid Core Compound Planetary Gearbox (customizable)

by

tmackay

Follow
Follow
Remix Model
Like
Solid Core Compound Planetary Gearbox (customizable) 3d model
2D
3D
Makes
Be the first to upload a make
This model is restricted by licensing terms. 
0 Likes4 DownloadsOctober 16, 2021
This model is restricted by licensing terms. 


Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3511382.

To follow on from previous designs, if we target less extreme gear ratios we have more room to move with our choice of gears. In particular, it would be most beneficial to have fused sun gears in both stages. This would allow for the drive force to be distributed over a larger contact surface, assist in initial post print processing and improve efficiency.

A fused sun gear introduces a constraint that the sun gear teeth is a multiple of the corresponding planet gear teeth, so that it is in effect a mirror of the planet gears and the two stages turn in unison with the planets in a 1:1 ratio. Even with this constraint, some absurd gear ratios are still possible (up to 616:1 within the range of gears specified in this customizer) but around 50:1 to 100:1 seems a good target based on existing designs.

Incorporating 3-layered approach from https://www.thingiverse.com/thing:3210223 and https://www.thingiverse.com/Gear_Down_For_What/about to make a practical gearbox. Eventually I'll probably make this gearbox compatible with the others, but for now I'm still playing with the arrangement of gears.

Where this series differs is the departure from the usual teeth relationship of R=S+2P. We are allowing some flexibility in our ring gear tooth count by dropping teeth and stretching the ring gear (easier to stretch than compress and maintain clearance). This is what allows more choice of gear combinations.

This model is a bit less forgiving in terms of input values. Use this spreadsheet to choose appropriate values.

In summary, what this design brings to the table are:

  1. Customizable for many gear ratios and dimensions
  2. Single piece sun gear, increasing efficiency, strength and distributing load
  3. Potentially more available gear ratios by violating R=S+2P constraint
  4. Print-in-place fully assembled. Potentially we could have multiple degrees of freedom of a robot arm printed in one pre-assembled unit.

(One last thing: The scad is a dog's breakfast, I know. I've been chopping and changing so much to experiment with different ideas. It probably has bugs too. I'll tidy that up, eventually, when I settle on a final design, which might be never. Welcome to the home of unfinished projects.)


0 Likes4 DownloadsOctober 16, 2021




This model is restricted by licensing terms. 
0 Likes4 DownloadsOctober 16, 2021
This model is restricted by licensing terms.