Mini Crusher

Nespresso Capsule Crusher v2.stl

Improved Stanley Razors and Cover

I present to you, another remix of this awesome little scraper. This version has a few nice upgrades that I felt would make this a bit more durable and safer. Basically I made some chonky bois because I knew full well with the way I would use these at work, I would snap it on the first use. They’re now 6mm thick and the long version is even longer at 120mm. I made the short version a little longer too just to make the dimensions an even number because… OCD. Anyways, I also redesigned the way it holds blades. After messing around with the original one, I felt like if you pressed hard enough on the back side that you could pop the blade out. And no matter how good your safety-squints are, no one wants a razor blade to the face. The slot fits a standard utility blade pretty snugly and whether you use supports or play with bridge settings, you’ll likely have to clean out the slot a little to get the blade to seat properly. This can print with or without supports, just takes some clean up afterwards either way. This redesign still uses M3 hardware and the holes are countersunk to give it a clean look. I only had M3x6 screws on hand so they kind of poked through the back, if you have M3x3 or M3x4 screws, those would probably work better. I also included files for a cover I found that I made some changes to so it would better fit these scrapers. I printed the scrapers with 3 walls and 75% infill for increased strength from Sunlu PLA with 0.2mm layer height. 

Aluminum Card Jig

Remix/redesign of some card jigs I've seen. This jig fits standard aluminum cards found on Amazon, the ones I have measure 54mm tall and 86mm wide. Printed on the X1C with 0.2mm layer height and 30% infill at standard speed, there was maybe .001" of play around the card when placed in the jig which shouldn't cause any problems when marking the card with the laser.  This is designed to fit most fiber laser beds with 25mm center-spaced holes. This jig allows the use of the four socket head cap screws that come with most machines which I believe are M6x10 and has countersunk holes so the screws fit flush for a clean look. The picture uploaded is of the first version I designed that has text in the middle and lacked a recess to be able to pick the card up. The uploaded version has the text removed (I didn't care for it) and has a recess to make picking the card up easier. I didn't feel like printing the updated one just for the picture. Enjoy!

Duct Funnel

Simple duct funnel thing designed to fit most fiber laser threaded bases with holes spaced 25mm on center. Fits 4" dryer duct and has holes to screw it to the table using M6x1 screws. The duct is 8" wide, 5" tall and 4" deep. 

tjnucci

Achievements

Seedling

Mini Crusher

Improved Stanley Razors and Cover

Aluminum Card Jig

Duct Funnel