A gridfinity insert (5x7 units) sized to fit an IKEA Kvissle drawer. I'd suggest pulling off the cork bases then gluing down the insert — I'm not sure if the drawer will still fit in the slides with both the cork and the insert installed.

The insert is fairly low-profile, and leaves about 60mm/2 3/8" of space between the top of the insert and the bottom of the drawer above (or top of the set).

I've noticed the Kvissle sets bowing out near the middle, causing the shelves to occasionally fall off their rails. Mine are sitting in cubbies on an IKEA Kallax shelf, so I also designed some clips to hold the Kvissle sets in place and keep the walls from bowing outwards. Those can be found here.

I split the base in two for easier printing, with tabs to hold them together. If the parts don't fit on your print-bed, please let me know in the comments, and I'll see if I can put together a version that's cut into smaller pieces.

The gridfinity bin featured in the first picture is the "Gridfinity Framework Laptop Expansion Card Holder" by Dayrl Biggins, and can be found here.

The grid portion of this print was generated with the "GridfinityGenerator" plugin for Fusion360 by Lev Mishin, which can be found here.