Light switch cover02.stl

Power Board Holder 001.stl

Holds the unused half a pill when you have to divide them.

I have one of those medications now, and it always annoyed me to put the half pill back into the bottle, you end up with a load of crumbling half pills and dust. I tried keeping the remnant in the little dimple in the lid but it's way too easy to dislodge. This way the half pill stays with the bottle and doesn't roll off the lid.

Peace out!
Ted.

Also, make sure to check out my blogs, take out a subscription, or a make a donation:
Ted's News Stand: https://www.ohaicorona.com/teds-news-stand/ 
Newsletter signup: https://www.subscribepage.com/tedamailxpress
Paypal Donation: http://paypal.me/teddlesruss 
Ko-Fi page: https://ko-fi.com/ptec3d or https://ko-fi.com/grumpsy


Pillbottle Topper.stl

You open one of those little tubs of tomato paste, you use half to make a meal, you press the foil lid back down, and shove it in the fridge. Two days later, you want to use the rest and get it - and there's biology taking place in there, lovely splotches of mold. 

THAT is why I finally made and printed this lid. Simples.

NOTE: Tomato Paste Lid.stl is the first version, it's not drawn with smooth curves and I made it a touch smaller so it wouldn't bind in the tub, figuring I'd fix it up for the second draft - but this was good enough for the moment. I'll smoothe it out and increase the diameter by a millimetre and add Tomato Paste Lid v2.stl when I get a moment to do it.

Peace out!
Ted.

Also, make sure to check out my blogs, take out a subscription, or a make a donation:
Ted's News Stand: https://www.ohaicorona.com/teds-news-stand/ 
Newsletter signup: https://www.subscribepage.com/tedamailxpress
Paypal Donation: http://paypal.me/teddlesruss 
Ko-Fi page: https://ko-fi.com/ptec3d or https://ko-fi.com/grumpsy


Tomato Paste Lid.stl

Housing for an IR touch-free LED strip controller

LED strip touch-free switch housing

Light switch all01.stl

~Simple mount plate for Xiaomi BT thermometer~

Xiaomi BT thermometer mopunt plate

Just a wall mount for the $2 power boards that every discount store seems to sell. You need two. And use flat head screws not countersunk, I recommend button head. 

Power Board Holder 001 (repaired).stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like