Great for Workspaces - No Supports Needed - Fits Most Phones with Cases

This is a simple but sturdy phone stand I designed for my own desk setup. It holds your phone at a comfortable viewing angle and prints flat without any supports. The design is clean and low-profile, but stable enough for everyday use.

• Holds most phones with cases
• Front lips keep the phone from sliding off
• Good viewing angle (about 60 degrees)
• Support-free, easy print
• Designed to sit solidly on any desk

Print Info:

Orientation: Flat

Layer Height: 0.2mm

No supports

Works well in PLA or PETG

I designed this for myself, and it worked so well I figured I would share it.