tracking pixel
Skyy B

Trimble (32mm) Mount.SLDPRT

by
skyybl3u
Follow
Follow
Remix Model
skyybl3u
skyybl3u
|
Image 1 of 3
Trimble (32mm) Mount.SLDPRT 3d model
skyybl3u
skyybl3u
|
Image 1 of 3
Trimble (32mm) Mount.SLDPRT 3d model
2D
3D
Makes
Trimble (32mm) Mount.SLDPRT 3d model
Trimble (32mm) Mount.SLDPRT 3d model
Trimble (32mm) Mount.SLDPRT 3d model
This model is restricted by licensing terms. 

Designed for Parnell 32mm Trimble 2M pole extensions. Includes a single and double mount in both STL and SLDPRT (roll forward SLDPRT for double mount)

Feel free to not use all the holes provided or use double-sided tape -- though fair warning; the pole does snap into place quite firmly and poorly calibrated printers may create too much friction to safely pull off of drywall. Increase scaling by 0.5-2% before printing if this is the case, as it is also possible to rest a bubble gauge on the upper lip if there is not enough friction to hold the pole in place after scaling.

Print upside down, no supports, medium infill, 3 walls minimum (5-8 recommended)

Edited: 05-10-2024 Optimize clamp diameter


0 Likes2 DownloadsMay 7, 2024



0 Likes2 DownloadsMay 7, 2024
This model is restricted by licensing terms.