tracking pixel
Spencer

Refrigerator Thermometer Stands

by
sj3Dprints
Follow
Follow
Remix Model
sj3Dprints
sj3Dprints
|
Image 5 of 9
Refrigerator Thermometer Stands 3d model
sj3Dprints
sj3Dprints
|
Image 5 of 9
Refrigerator Thermometer Stands 3d model
2D
3D
Makes
Refrigerator Thermometer Stands 3d model
Refrigerator Thermometer Stands 3d model
Refrigerator Thermometer Stands 3d model
Refrigerator Thermometer Stands 3d model
Refrigerator Thermometer Stands 3d model
Refrigerator Thermometer Stands 3d model
Refrigerator Thermometer Stands 3d model
Refrigerator Thermometer Stands 3d model
Refrigerator Thermometer Stands 3d model
This model is restricted by licensing terms. 

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:6146342.

Refrigerator thermometers from the hardware store slide into these stands to improve stability or to allow them to be viewed from above when placed in the cheese drawer or bottom freezer. The end of the metal base slides under the rails on the printed stand to provide a snug fit.

I found 2 problems with the thermometers inside my refrigerator:

  1. They would constantly tip over due to the center of gravity being so close to the front edge. Any light tap or if the doors were shut with any force would knock them over.
  2. The dial is not easily visible when placed in the cheese drawer or bottom freezer.

My solution was to design a stand that would stabilize the thermometer by extending the base forward, and to design another stand that would allow the dial to be viewed from the top.

Link to refrigerator thermometer for reference: https://www.lowes.com/pd/Frigidaire-Universal-Refrigerator-Thermometer-Chrome/1004991

Print recommendations: Print the front facing stand in the vertical direction and with brim enabled. I set the brim width to 10 mm. The top facing stand does not require any special settings.


2 Likes2 DownloadsJuly 30, 2023



2 Likes2 DownloadsJuly 30, 2023
This model is restricted by licensing terms.