Turntable Test Coin

Ive used this a lot for test prints. About 25-40 minutes of tests isnt the greater test print, but is a lot better than some. It does have some over hangs and small parameters to check overhangs and bridging.

Ash Tray.SLDPRT

Its an Ash Tray. Its got a ninja on it. I have one I printed out of PLA that is fine after 10 months of use. Obviously, higher heat plastics could fair better over time.

Corner supports2.SLDPRT

Im pretty sure its a M4 hexnut that fits in this corner support

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

seejonflow

Achievements

Seedling

Turntable Test Coin

Ash Tray.SLDPRT

Corner supports2.SLDPRT