Ive used this a lot for test prints. About 25-40 minutes of tests isnt the greater test print, but is a lot better than some. It does have some over hangs and small parameters to check overhangs and bridging.

Turntable Test Coin

i guess this is a part that is created because the turntable is an obj file

defaultobject

Its an Ash Tray. Its got a ninja on it. I have one I printed out of PLA that is fine after 10 months of use. Obviously, higher heat plastics could fair better over time.

Ash Tray.SLDPRT

Im pretty sure its a M4 hexnut that fits in this corner support

Corner supports2.SLDPRT

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

seejonflow

Turntable Test Coin

Ash Tray.SLDPRT

Corner supports2.SLDPRT