tracking pixel
Robert M

Vibration Damping Feet

by
roborob
Follow
Follow
Remix Model
roborob
roborob
Image 1 of 3
Vibration Damping Feet 3d model
2D
3D
Makes
Vibration Damping Feet 3d model
Vibration Damping Feet 3d model
Vibration Damping Feet 3d model
This model is restricted by licensing terms. 
2 Likes5 DownloadsNovember 1, 2022
This model is restricted by licensing terms. 


Vibration Damping Feet

This model uses rubber stoppers to dampen vibrations between the printer and work surface.

  • Easy twist-in or M5 T-nut versions
  • 2020 and 2040 (etc.) compatible
  • Glue not required
  • Keeps printer stationary.
  • Optionally, you can cut a small circle of paper to put between the rubber stopper and work surface if you like to move your printer around.

East twist-in version:

  • Easy twist-in design!
  • May need additional post processing.
  • May need supports.

M5 T-nut version:

  • No support needed!
  • No additional post processing.
  • M5 T-nut and bolt required.

*You may need to resize the model to match your tolerances.

Rubber stoppers on Amazon: https://amzn.to/3U1YNHP

Just FYI: Damping and Dampening are synonymous. (Yes, I had to say it.) Rubber stoppers not included. T-nuts not included.


2 Likes5 DownloadsNovember 1, 2022




This model is restricted by licensing terms. 
2 Likes5 DownloadsNovember 1, 2022
This model is restricted by licensing terms.