Ornate Masquerade Mask by Perihelion Prints

=====

A traditional masquerade mask with "sequins" around the eyes and raised details drawn onto the surface.

=====

For attachment to head, use elastic cord or ribbon. Hot glue should work. For fitting, place the mask on your face, lining it up with your nose. Measure how much ribbon you'll need to go around your head, then add a bit more and cut two equal halves. Glue one to each side of the mask, and use the leftover length to tie both pieces into a knot or bow behind or head. Or you can edit the file to come up with your own solution.

Sculpted in Blender. STL and .blend files included. Dimensions in millimetres.

=====

"Evening Dress 1894" used in demo render (https://skfb.ly/ooPWR) by Tijerín Art Studio is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).

"Larisa" used in demo render (https://skfb.ly/pDJ8D) by Veterock is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).

=====

0.20mm layer height recommended.

Organic supports recommended.

PLA/PETG recommended.

Filament Usage (estimated): 62g

Printing Time (estimated): 5h30m

^ Estimates based off slicing for Prusa MK3.9. Your mileage may vary.

=====

Please note, the raised details will likely require significant support, although the amount shown in the picture may be overkill. But while organic supports may use more filament, they should be much easier to remove without causing significant surface defects, which is probably more important in this case.

Please reach out for assistance if you are unable to print the details nicely.