Dragon Queen Mask by Perihelion Prints

======

For attachment to head, use elastic cord or ribbon. For fitting, place the mask on your face, lining it up with your eyes and the sides of your face.

Measure how much ribbon you'll need to go around your head, then add a bit more and cut two equal halves. Tie a knot at the end of each piece of cord, or glue one to each side of the mask, and use the leftover length to tie both pieces into a knot/bow behind or head. Or you can edit the file to come up with your own solution.

Sculpted in Blender. STL and .blend files included. Dimensions in millimetres.

Comes in two variants as shown, with bigger or smaller eyes. The choice is yours.

AI was only used in the creation of the preview photos

======

0.20mm layer height recommended.

Use supports where appropriate - organic supports recommended.

You may need to slightly reposition it on your printer bed in order to fit it. Try to print as upright as possible for best results.

15% infill tested. PLA recommended.

Filament Usage (estimated): 70g

Printing Time (estimated): 4h45m

^ Estimates based off slicing for Prusa MK3.9. Your mileage may vary.