Intro This is a two-part sled for an Eggfinder Mini GPS receiver and transmitter, which is commonly used to locate model rockets. The sled zip-ties to the rocket's shock cord (there are notches at each end of it). It's designed to be printed without supports or a brim. So far, this has been printed using PLA-CF.

Attribution This model was inspired by RCOutlaw's Eggfinder GPS Mini on Thingiverse

Included

• Sled base with shock cord mount notches
• Sled cover with screw holes and guides for easy installation
• Assembly Manual
• Technical Drawings

Requirements

• Eggtimer Mini GPS
• 4x M3-10 screws (I found them at Ace Hardware)
• Battery (7.4v LiPO) with dimensions (must be less than or equal to in order to fit): 16mm wide x 46mm long x 12mm thick

Assembly See exploded diagram in model images. See attached user manual PDF for a better image.

• Install the Eggfinder Mini on the mounting posts on the side of the sled base with the rounded antenna protector using 2x M3-10 screws.
• Drop the battery in the sled base with wires routing out the back away from the Eggfinder
• Align the sled cover's guides onto the mounting posts for the cover. Secure with 2x M3-10 screws.