maxmicah44

0

Followers

0

Following

0

Model Views

0

Downloads

0

Comments

0

Likes

Achievements

Novice Maker

First Make published

0

Followers

0

Following

0

Model Views

0

Downloads

0

Comments

0

Likes

Sort by:

Pooping Balloon Dog - I used Lychee Slicer for this print and it was quite finicky.
After a lot of trial and error these are the settings I settled on.
I've attached my resin settings in the photos.
I printed directly on the build plate so there was a slight elephant foot effect which I just sanded off.
If I was going to print this again I'd increase the compensation on the burn in layers to .25.
I've also attached a photo of the model in the slicer with the supports used, I recommend using quite a bit more supports as every single one of the connect areas sagged.
Easily sanded to look much better but would have been easier if I set up more supports.
I would avoid using supports on the torso of the body because they can be a pain to remove.
Super happy with how it turned out.
I airbrushed it with one layer of white all over and topped that with 2 layers of red and some gloss mod podge.
Great model with minimal issues for this odd shape.
Thanks! - 3d model