This is a quick cable hanger I designed for running some cables around the wall at the ceiling in a closet.  Specifically, it's a little oversized for 3x Cat 6a network cables.  The idea is that the square back plate will go up against the ceiling, to keep it from rotating, and a #8 screw will sink into the 2x4 top plate.

Ceiling Hanger

Ceiling Hanger.stl

This is the top and bottom part of a grommet for holes in 5/8" to 3/4" plywood shelves I was building.

Shelf Grommet

This is an adapter for the input end of the Dust Deputy DIY to connect a 2" shopvac hose to.  It needs a "2.5 inch key hose clamp" to clamp it to the Dust Deputy, or glue, otherwise it comes off sometimes during use.

Dust Deputy to 2" Vacuum Hose

I designed this for my wife with the first initial L as a hook for her apron.  Thinner straps could possibly hold two of them, the straps on hers are bulkier and so it really can only hold one.  I attached it to the wall using 3M Command Strips.

Letter L Apron Hook

This is a bar that you can pull across the adjusting knob of a "GD-60F Leveling Caster" to more quickly raise or lower the leveling foot.  Search Amazon, these casters are available under many brand names.

Leveling Caster Speed Adjuster

This is an extension for the bean hopper on the Baratza Virtuoso coffee grinder.  The hopper holds 8oz of beans, but a normal small bag holds 12oz, and I could almost but not quite put a full bag into the hopper.

After a few weeks of trying it, I decided to epoxy it to the original hopper.

Baratza Virtuoso Hopper Extension

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like