Taurus TX22 Magazine Holder

GSG Firefly / Sig Mosquito Magazine Holder

CZ 75 B Magazine Holder

Ruger EC9s, LC9s, LCP II Magazine Holder

Heckler and Koch MP5 K-PDW BB Magazine SpeedLoader V3

Hi-Point 9mm Carbine Magazine organizer

Nikon EN-EL19 Spare Battery Holder *CUSTOMIZABLE*

Ruger 10/22 .177 Air Rifle Wheel Magazine Holdr

Tarus TX22 16Rd Magazine Spring Retainer

SteelStormBBFillHolderV3.stl

I'm working on a holster for my Umarex Steel Storm BB Gun, but the BB reservoir slides open at the slightest touch, dumping my BBs all over the ground. So a little time in Tinker-cad and 3 iterations I have this, a clip-on retainer that holds the front sight in place and keeps the reservoir closed. Print on end without supports and press-fit as in photos and happy plinking!

Tinkercad Design available:
https://www.tinkercad.com/things/31RvuXaGWw1


Walther PPK-S Loader V6.stl

BB Drop-in speed-loader for the Umarex Walther PPK/S BB pistol. Print in original orientation or on back with bb-hole up. Slip in the back of the magazine facing up/towards hopper until spring is compressed and drop in BBs until full. Ream magazine holes if printer does not have dimensional accuracy.

Tinker Cad Original Design available.
https://www.tinkercad.com/things/eWTu0N0BhJf

H&K MP5 BB Speedloader V3.stl

Version 3 of the H&K MP5 Magazine loading little .177 Cal (4.5mm) BB's sucks, even with the good magazines that Umarex provides with the H&K MP5 K-PDW. This is a speed-loader for the magazines to drop those 40 little balls into the magazine.

Print at 100% in the orientation provided 3-ish Hrs on Ender 3 High Quality, PLA, clean out the support and ream out the BB hole to ensure easy BB passage and no plastic in your magazine.

Pull Magazine Follower back until locks, place on top of magazine, should be snug. This holds the retaining latch back so the BBs should just fall into the magazine. Lightly shake if you get a BB Jam at the hole. I may make one that has a 40 BB Measure/larger hopper, but as is this cuts loading time down to about 10-20 seconds.

Designed in TinkerCad. You can Tinker it yourself
https://www.tinkercad.com/things/63p5vOr6GbR

Moving from Thingiverse due to the cruddy support and demands for Ads.

I'll be deleting my work from there once I become comfortable with the system. 

kyootfox

Achievements

Seedling

Debutant

Voyager