This model is restricted by licensing terms.
View license.
Test part to analyse the best hole offset to use in the conception of your parts.
Print the test part. With a Caliper controle the hole diameter. If you think these values are not correct, you can use the Hole Horizontal Expansion parameter to set the right offset on the holes.
Hole diameter: 1 mm ~ 15 mm
Printing Conditions:
- Nozzle Size : 0.4
- Layer Height : 0.2
- Initial Layer Height : 0.2
- Line Width : 0.4
- Wall Line Count : 3
- Fill Gaps Between Walls : Nowhere
Estimated printing Time = 35 min
Category:
14 Likes29 DownloadsMarch 25, 2022
14 Likes29 DownloadsMarch 25, 2022
This model is restricted by licensing terms.
View license.