A cup holder compatible with Thule Spring and Thule Shine. Holds a 40oz water bottle or a 30oz Yeti Tumbler.

Stroller attachment point taken from MottN's Thule stroller cup holder (Spring and Shine). Fusion360 model attached.

If I reprint this I may remake this with the following modification:

• Shorten model :: It was printed to accommodate my 295mm tall water bottle. Shrinking it by 30% shouldn't affect its efficacy would reduce bulk.
• Shorter bottom well :: Its far deeper than it needs to be.
• Recess mount point :: Currently this must be printed with supports. Adding a recessed mount point should allow it be printed on its back without supports.
• Partial Bottom well :: Cutting of 1/3 of the width of the well should reduce the footprint when not in use, and & eliminate the need for drainage