Make bath time fun!

I was inspired to make this little toy water pump when the pump I wanted buy my toddler was out of stock.

Print all models as oriented in the STL in the following quantity:

• (1) Base.stl
• (2) Valve.stl
• (1) Pipe.stl
• (1) Plunger.stl
• (1) Spout.stl
• (1) PlungerCap.stl

Note that following parts require supports from the build plate only:

• Base.stl
• Plunger.stl

Assembly instructions:

1. Insert and snap fit a Valve into the Base
2. Insert a snap fit Valve into the Plunger
3. Insert the Plunger into the Spout
4. Snap fit the PlungerCap onto the top of the Plunger
5. Screw the Pipe onto the Base
6. Screw the Base onto the Pipe

Usage:

1. Submerge the bottom of the pump into water
2. Pump the Plunger until the Pump primes
3. Enjoy the water pumping out the spout!