Anker Soundcore Q20 ear cup adapters.stl

These are simple spacers which fit the plastic clips on the soundcore q20 and create a flat mating surface for traditional ear cups like replacements like those for the beats studio.  Print one reversed to fit each side.

Duup-Wluff presta valve.stl

Why should schrader have all the fun
based on https://thangs.com/designer/andromeda/3d-model/Duup-Wluff-812684

Beats solo driver headphones

Headphone strap.stl

Sony Walkman WM-FX290W battery door.stl

Just a quick print to fix one of the most classic problems with this device.  You probably wont need supports.  I printed this at a resolution of .28 with PETG and it came out functional.  Good luck.

Airsoft Hexagon Flash Hider

Keep in mind 3d printed threads are not always accurate.  These threads are 14mm negative but run small so print with multiple walls and in a less brittle material.

Soap DIsh

Soap Dish Top.stl

long pull shifter friction shifter

Bar mounted shifter based on https://www.thingiverse.com/thing:112602 but modified for use with wide range/mtb derailleurs.  It has about 1.4 times the pull ratio of a normal shifter.  The lever has been made longer to compensate.  It is also reversed like a shifter for a front derailleur but this is because it is intended to be mounted on the bottom of a right bar.

Non-printed parts:
2x #10 Nylon Lock Nuts
2x #10 x 1" Machine Screws
1x #10 Washers
1x 1-1/4" fender washer
2x 1-1/4' rubber washers
Splicing tape (or thin piece of rubber) for mounting (standard electrical tape does not work) 

jasondarby01

Achievements

Seedling

Trailblazer

Debutant