I based this model off of the filaments below, but I actually used some generic black, generic orange, Eryone Burnt Titanium, and generic white filament and I think it looks great. Should be able to adjust the X/Y size, but make sure the Z height stays where it is or the model won't work.
If you've never made a Hueforge print before, it may look complex, but it's pretty easy. Just make sure your filament is dry, clean your bed well, level your bed, and apply glue stick if needed. No AMS/MMU is needed; just add pauses at the layers below and switch the filament when your printer stops.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
Filaments Used: PLA Sunlu Meta Black Transmission Distance: 1 PLA Protopasta Out of Darts Orange Transmission Distance: 11 PLA Protopasta Good as Gold Transmission Distance: 5 PLA Sunlu Matte White Transmission Distance: 5
Swap Instructions: Start with Black At layer #14 (0.68mm) swap to Out of Darts Orange At layer #20 (0.92mm) swap to Good as Gold At layer #26 (1.16mm) swap to White for the rest.
I included an STL and 3MF file for this model.
If you print this model, please upload pictures! :)