End of The Roll Phone Stand

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5387206.

This is a remixed version of my previous 2 angle phone stand design, modified to be thinner and use less filament. It is a little less stiff so I don't think it would hold an Ipad, but it works fine with both large and small phones as shown in the pictures. The structure was shelled to minimize material (main bode is a single extrusion width), but the ribs on the edges stiffen the structure significantly. Prusa slicer says 1.89m of filament for the print. It should be printed on edge as shown in the .stl, the transitions have been filleted so that no supports are needed.