Do not take care about the provided 3mf-file! It's just for viewing purposes only!
Attached you'll find the Fusion360-File which is based on the original "1x1-Multibin Top - STEP Remixing File.obj" provided on the Multiboard.io page (You need to download the "Original"-file to access the .f3d-file) . The advantage is, that this "Template" is already cleaned up for all unnecessary triangles and therefore will provide a solid basis for your designs in Fusion360.

Fusion360 Multibin Top Remixing Template

Multibin Top Remixing.3mf

Remix of the 1x1x0.75 Multigrid bin. I just put a ramp on one lower inside corner to make it easier to pull small parts out of the bin. Additionally a plate to place a label on it. This plate also allows to pull out the bin if it's surrounded by other bins.
The Label is placed at the level of the lower notch to do not hinder stacking.
Printing is possible without support.


Remix 1x1x0.75 - No Lock Holes - ramped - Labelplate - Multigrid Bin

1x1x0.75 - No Lock Holes - ramped - Labelplate - Multigrid Bin.3mf

Remix of the 1x1x0.75 Multigrid bin. I just put a ramp on one lower inside corner to make it easier to pull small parts out of the bin.

Remix 1x1x0.75 - No Lock Holes - ramped - Multigrid Bin

1x1x0.75 - No Lock Holes - ramped - Multigrid Bin.3mf

A plate to clip into a 1 unit wide Multigrid bin to place a printed label on. Additionally it makes it easier to grab a bin surrounded by other bins. It uses the Rim Lock holes and the notch for fixation. To give it more hold, it could make sense to add some glue but holding is very good even without it.
As the notch seems not to be symetrical, there is an L on the lower side of the plate.

Multigrid Bin Label Plate

Multigrid Bin Label Plate.3mf

Holder for Wire Stripper Tool which hopefully fit's for several vendor related types of wire strippers.
2 Multiboard "[10 mm Mid Thread, Flat Head, T-Bolt](https://thangs.com/designer/Keep%20Making/3d-model/10%20mm%20Mid%20Thread%2C%20Flat%20Head%2C%20T-Bolt-974085)s" are required for mounting.
I also attached my Fusion 360 file to allow easier remakes.

MultiBoard Wire Stripper Holder

MB_Wire_Stripper_Holder.3mf

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

hmax

Achievements

Seedling

Voyager

Debutant

Fusion360 Multibin Top Remixing Template

Remix 1x1x0.75 - No Lock Holes - ramped - Labelplate - Multigrid Bin

Remix 1x1x0.75 - No Lock Holes - ramped - Multigrid Bin

Multigrid Bin Label Plate

MultiBoard Wire Stripper Holder