Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4893048.
Remake of my plug-in magic 8 ball.
You will need some basic Arduino and soldering skills for this. You can get the info you need for the Arduino skills at www.Arduino.cc
With a little bit of practice and training you can easily change all of the responses.
Setting up electronics on a breadboard print to printing is a good idea.
Wiring setup: Battery holder: Positive to B+ on Charger Board Negative to B- on Charger Board
Charger Board: Out+ to PIN 30 (VIN) on Nano 33 Out- to PIN 29 (GND) on Nano 33
Nano 33: PN 4 (GND) to GND on OLED PIN 17 (3.3v) to VCC on OLED PIN 23 to SDA on OLED PIN 24 to SCL on OLED
PART LIST:
Jumper wires and/or soldering setup.
Battery holder https://www.amazon.com/dp/B00LSG5BKO/ref=cm_sw_em_r_mt_dp_66Q4CJF6CMS4ZG26CWQS?_encoding=UTF8&psc=1
Charger board https://www.amazon.com/dp/B00LTQU2RK/ref=cm_sw_em_r_mt_dp_SNPDM7BEHPXMW4NR1PA1?_encoding=UTF8&psc=1
Nano https://www.amazon.com/dp/B07WV59YTZ/ref=cm_sw_em_r_mt_dp_Z8989X72S619W05CXSWT?_encoding=UTF8&psc=1
Screen https://www.amazon.com/dp/B08LYL7QFQ/ref=cm_sw_em_r_mt_dp_CP87FPW8CZRK0F9EV4GM?_encoding=UTF8&psc=1
Magnets: https://www.amazon.com/dp/B07873ZCY4/ref=cm_sw_em_r_mt_dp_MC788KGSXTP0GN3GPN6W?_encoding=UTF8&psc=1
Any 18650 battery