CR 10V2/3 Control box fan stand

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4835805.

Replace your control box exhaust and board fans on CR10 V2/3

You will need an assortment of M3 bolts and some nuts to complete this project.

The design allows you to pull nuts into the base before attaching fans. Use a shorter bolt and some washers on the bolt head and pull nuts to slot. Remove bolts and just larger bolts to bolt fans on in a later step.

Open case and disconnect fans from board.

Set case bottom aside.

Bolts two pieces together.

Bolt fans on. The one towards the front should have sticker down (exhaust) the back one sticker up (intake).

Test fit fan wiring. I had to extend the front one.

Orient feet up

Print 6 foot cushions from TPU if you wish