This Rugged Box holds two 18650 batteries.

Material: PETG Layer Height: 0.2mm Speed: 25 Nozzle Temp: 235 Bed Temp: 70

Needed for Allembly: 2- Bottom/Top 2- Hinges 2- Clasps 1- Seal A 1- Seal B 1- Label (Optional) 4- 53mm pieces of filament to act as hinge pins

Instructions for Label: Print Label At single layer height (0.2mm) in center of bed.(Cura centers automatically). Turn bed heat back on immediately when finished. Remove skirt from print bed. Change to new filament color. Print Top Directly over Label centered on bed. (again, Cura centers automatically).

Note: If using BLTouch, when printing Top over the Label, it will be necessary to lower Z Offset by 0.2mm if the probe touches the label at the beginning of print.