Ender 2 Pro, Ender 3 S1, Pro Raspberry Pi mount 3d model

Ender 2 Pro, Ender 3 S1, Pro Raspberry Pi mount

87 downloads · 4 years ago · This is just a simple mount for a 30 x 60 x 90mm Raspberry Pi case with touchscreen that can be a de

This model is restricted by licensing terms.

View license.

Description

This is just a simple mount for a 30 x 60 x 90mm Raspberry Pi case with touchscreen that can be a desk standalone or mounts to the side of the Ender 2, 2 Pro 3D Printer replacing the factory touch screen. It also has mounting provisions to mount on the right side of the Ender 3 S1 and S1 Pro as well. It may fit other Ender Series not too sure I do not know all the model mount points. I added a provision to make it possible to rotate the Pi 180 degrees placing the USB-c connector on the right side for the Ender 3 S1 model on the right.

Tags:

Discussions

eclypse3demons4 years ago

I made this mount for those small Raspberry PI cases they measure 30 x 60 x 90mm and may work with other similar cases that support the RPI 4 B model other similar models may work. It places the IO at the bottom and power and HDMI out on the left on the Ender 2/Pro and on the Ender 3 S1/Pro you can orientate it both ways with IO at top or bottom and power out on left or right, but note only power out is reachable on the right as I only provisioned a window for the USB-c connector. It was meant to be used for the screen not for output. Because of the angle on the right hand side mounting unless you modify the model to raise the left side base of the mount higher than the top deck of the Ender three you will not be able to access the video IO on the left side either.

You can edit the model to your liking... =)