Parts for rigid mount for BIQU H2 extruder for Ender 3V2. Plate is a modified plate purchased on Amazon, two holes for the BIQU H2 are required to be drilled. Note the Z carriage needs to be cut back below the 2020 extrusion for the X carriage to accommodate the lower roller bolt on the X carriage. The cut back dimensions are not critical and can be done with a hacksaw and file, see the picture. Purchased plate was... balikha 3D Printer Alloy Direct Drive Extruder Plate for Ender-3/V2/CR-10 The plate requires the X and Y carriage stops to be adjusted. Simple 3D printed spacers are used. There is an X carriage stop for use with a BLTouch and one for no BLTouch. I printed the spacers in PLA3D850 because of its higher heat resistance. That way I can use them in a heated enclosure.