For all the cat lovers out there, here's a lovely print of potentially your favourite feline friend.
The included 3MF file will already have all Bambu Studio/Bambu printer settings and layer swaps applied. If you do not use Bambu Studio or a Bambu printer, please download the STL and follow the following print instructions:
Print instructions: Print at 100% infill with a layer height of 0.04mm with a base layer of 0.20mm. If you only have one AMS, once the black section is done printing, you can remove the black spool and replace it with the final colour (white). In your slicer, make sure slot Black and White are both assigned to the same slot (for example, A1).
Filaments Used:
- PLA Kingroon Black Transmission Distance: 0.4
- PLA CC3D Blue Gray Transmission Distance: 3
- PLA CC3D Orange Transmission Distance: 7.4
- PLA Sunlu Beige Transmission Distance: 8.2
- PLA BambuLab Basic Jade White Transmission Distance: 5
Swap Instructions:
- Start with Black
- At layer #11 (0.6mm) swap to Blue Gray
- At layer #16 (0.8mm) swap to Orange
- At layer #21 (1mm) swap to Beige
- At layer #34 (1.52mm) swap to Jade White for the rest.
If you'd like to support me, I now have a Patreon!
Joining will give you behind the scenes information on WIPs, access to a private discord, early access AND exclusive models!
If you want to sell any physical models I have uploaded anywhere, an unrestricted commercial license is available on the $10AUD tier of my Patreon!