This model is restricted by licensing terms.
View license.
62 Likes224 DownloadsDecember 5, 2023
This model is restricted by licensing terms.
View license.
This model utilises two white filaments of different TDs to achieve the smooth transitions you see in the image attached. I used both a low TD and high TD white for this, so for best results, you should use something similar too!
Print Instructions
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm
Filaments Used:
- PLA Kingroon Black Transmission Distance: 0.4
- PLA+ eSun Grey Transmission Distance: 1.4
- PLA Sunlu Beige Transmission Distance: 8.2
- PLA Kingroon White Transmission Distance: 8
- PLA BambuLab Basic Jade White Transmission Distance: 5
Swap Instructions:
- Start with Black
- At layer #19 (0.92mm) swap to Grey
- At layer #22 (1.04mm) swap to Beige
- At layer #32 (1.44mm) swap to White
- At layer #39 (1.72mm) swap to Jade White for the rest.
If you'd like to support me, I now have a Patreon!
Joining will give you behind the scenes information on WIPs, access to a private discord, early access AND exclusive models!
If you want to sell any physical models I have uploaded anywhere, an unrestricted commercial license is available on the $10AUD tier of my Patreon!
62 Likes224 DownloadsDecember 5, 2023
This model is restricted by licensing terms.
View license.
62 Likes224 DownloadsDecember 5, 2023
This model is restricted by licensing terms.
View license.