Out of this World - HueForge Print
The beauty about this particular print is that it's whimsical in a way that you can use whatever colours you want and not have to use mine. I did use 6 colours for this because I was feeling feisty, but feel free to throw your own spin on it if you want to!
The 3MF should have all filament swaps loaded in. But, again, this print begs creativity so feel free to use whatever colours you want! STL file provided as well for non-Bambu users!
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm
Filaments Used:
- PLA Kingroon Black Transmission Distance: 0.3
- PLA+ Overture Dark Blue Transmission Distance: 4
- PLA META Sunlu Teal Transmission Distance: 5.4
- PLA BambuLab Basic Red Transmission Distance: 5
- PLA CC3D Lemon Yellow Transmission Distance: 8
- PLA BambuLab Basic Jade White Transmission Distance: 5
Swap Instructions:
- Start with Black
- At layer #11 (0.6mm) swap to Dark Blue
- At layer #18 (0.88mm) swap to Teal
- At layer #20 (0.96mm) swap to Red
- At layer #27 (1.24mm) swap to Lemon Yellow
- At layer #41 (1.8mm) swap to Jade White for the rest.
If you'd like my work and would like to support me, you can now subscribe to a Thangs membership plan!
Joining will give you access to a private discord, all paid models, early access to some models as well as a commercial license to sell the physical prints of my models.
If a Thangs Membership is not your thing, I also have a Patreon that gives you the same perks!