Here's a little banged-up, grungy HueForged Spidey. I used 5 colours for this one, but if you want to just use four on a single AMS, you can probably remove the yellow and just go straight from red to white.

The 3MF file has all the Bambu settings already applied. If you don't want to use the 3MF, then load up the STL and follow the instructions below:

Print Instructions Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4
• PLA+ Overture Dark Blue Transmission Distance: 1.8
• PLA BambuLab Basic Red Transmission Distance: 5
• PLA CC3D Lemon Yellow Transmission Distance: 8
• PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:

• Start with Black
• At layer #10 (0.92mm) swap to Dark Blue
• At layer #12 (1.08mm) swap to Red
• At layer #17 (1.48mm) swap to Lemon Yellow
• At layer #19 (1.64mm) swap to Jade White for the rest.

If you'd like to support me, I now have a Patreon!

Joining will give you behind the scenes information on WIPs, access to a private discord, and early access to models. If you subscribe to the $10AUD tier, you also get these paid models included!

If you want to sell any physical models I have uploaded anywhere, an unrestricted commercial license is available on the $10AUD tier of my Patreon!