tracking pixel
cyanidesugar

Boo!ba Tea Keychain

by
cyanidesugar
Follow
Follow
Remix Model
Like
cyanidesugar
cyanidesugar
Image 1 of 3
Boo!ba Tea Keychain 3d model
2D
3D
Makes
Boo!ba Tea Keychain 3d model
Boo!ba Tea Keychain 3d model
Boo!ba Tea Keychain 3d model
This model is restricted by licensing terms. 
32 Likes22 DownloadsOctober 15, 2023
This model is restricted by licensing terms. 


Fancy some Halloween Boba Tea? Well now you have a keychain for it! Just a cute little gift for every Halloween / Boba loving person out there. I present to you the Boo!Ba Tea Keychain!

The keychain is 5cm wide and 6.5cm tall. If you want to make this bigger or smaller, you can scale it in your slicer, however you HAVE TO UNTICK ‘uniform’ scale and make sure the Z (height) dimension is always 2.43mm no matter what the other measurements are.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

Filaments Used:

  • PLA Kingroon Black Transmission Distance: 0.4
  • PLA Overture Cream Transmission Distance: 8.4
  • PLA Sunlu Beige Transmission Distance: 8.2
  • PLA Kingroon White Transmission Distance: 8

Swap Instructions:

  • Start with Black
  • At layer #11 (1mm) swap to Cream
  • At layer #21 (1.8mm) swap to Beige
  • At layer #24 (2.04mm) swap to White for the rest.

32 Likes22 DownloadsOctober 15, 2023




This model is restricted by licensing terms. 
32 Likes22 DownloadsOctober 15, 2023
This model is restricted by licensing terms.