Death Note fans, this one's for you! (but mainly, for my bro-in-law who requested it).
Pretty simple print at 0.08mm layer heights that takes just under 3 hours to print (if you use my 3MF Settings).
If you do not use my 3MF settings (or if you do not use a Bambu Printer/Bambu Studio) - please follow the instructions below. If you wish to resize the print please DO NOT resize the Z dimension and only resize the X and Y dimensions.
Print Instructions: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm
The Model is 134.49x240mm in size You may print at higher layer heights below the Min Depth of 0.44mm The Max Depth is 2mm and the Actual Depth is 2.1mm
Filaments Used:
- PLA BambuLab Matte Charcoal Transmission Distance: 0.6
- PLA Chrominal Penumbra Gray Transmission Distance: 6.9
- PLA BambuLab Tough Vermilion Red Transmission Distance: 3
- PLA CC3D Lemon Yellow Transmission Distance: 6.8
- PLA Kingroon White Transmission Distance: 5.8 This print uses 5 unique filaments
Swap Instructions:
- Start with Charcoal
- At layer 0.68mm swap to Penumbra Gray
- At layer 0.84mm swap to Vermilion Red
- At layer 1.08mm swap to Lemon Yellow
- At layer 1.24mm swap to White for the rest.
If you'd like my work and would like to support me, you can now subscribe to a Thangs membership plan!, or if you prefer, my Patreon.
Joining will give you access to a private discord, all paid models, early access to some models as well as a commercial license to sell the physical prints of my models.