This model is restricted by licensing terms.
View license.
11 Likes18 DownloadsApril 15, 2022
This model is restricted by licensing terms.
View license.
MiniDisk - Rack
Since I own a ton of MD's without any sleeves/cases around it I decided to make a Rack so they can fit in snuggly without the sleeves. There are 2 holes in the back of them so you can hang them up in 2 ways. If you like HoneyCombs I also included one so you can stack them up or make a honeycomb grid on the wall...
NOTE! ONLY FOR MD's WITHOUT SLEEVES FIT IN IT!
No support needed when printing. I even printed one with the front side on the bed to get that nice Prusa Textured PEI Sheet look and the bridging was perfect!
I printed mine with FormFutura's Volcano PLA Black.
Category:
11 Likes18 DownloadsApril 15, 2022
This model is restricted by licensing terms.
View license.
11 Likes18 DownloadsApril 15, 2022
This model is restricted by licensing terms.
View license.