Particle Ethernet FeatherWing Enclosure

Particle Ethernet Enclosure - Bottom.stl

Hexpansion Smile

Hexpansion Smile v5a.stl

Hexpansion Eyes

Hexpansion Eye v1.stl

Pad Stand

A simple 3D printed stand for holding a tablet at a near vertical angle.

Wire Clip (5mm)

A simple clip that allows a 5mm wire frame to be attached to a sheet of wood, or anything else for that matter.

W5100S-EVB-Pico Holder

This is a holder for the WIZnet W5100S-EVB-Pico clone with Ethernet built in. After headers have been attached it should slip in and pop down securely enough to stop movement, but it can still be pulled out. The holder can be taped or glued.

Door Release Reset

Special pin required to reset some door release buttons. 

Magnet Holder

A simple plastic magnet holder that is used to hang things from the magnet. Printed in TPU a 3mm deep magnet with a 12mm diameter is glued in to place. This can then have a thread or wire placed through the hold and hung from metal pipes, or anything else a magnet will stick to.

Antenna Magnetic Base

A replacement base for low cost antennas that do not have enough grip to keep them attached to a moving car. Just remove the old base sticker and magnet, replace with a 3mm thick rare earth magnet, and push the base on. Needs to be printed in a flexible material like TPU.

 Microphone Stand Phone Holder

Microphone_stand_phone_holder_-_Base.stl

Pi Zero and MMDVM HS Hat Case

Symmetric Keyhole Hook

Prusa Original i3 Replacement Foot

Door Lock Cap

Magnet Holding Enclosure Foot

Chair Foot (for Senator T104 and comparable)

IR Sensor Holder

Door Stop / Wedge

Replacement Sticky Tape Holder "Middle bit"

LCD Thermostat Holder

Drill Size Tester

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

alistairmacdonald

Achievements

Seedling

Debutant