Gripper finger for the Quickshot/Spectravideo SVI-2000 robot arm.

Model is symmetric, so it fits either left or right side.

This is not a direct replacement of the original fingers, as I've lost the original fingers. In other words, you can't replace just one of the fingers with this model. You'll need to replace both.

Attach some self-adhesive rubber sheet to the finger tips for better grip.

SVI-2000 robot gripper finger

Part H4 for the original Tamiya Dyna Blaster RC car.

Drill the small holes to 2.5mm and tap with M3 threads.

Drill the large center hole to ~6mm to fit the axle. Drill the space for the bearings to ~8mm.

The spacer washer under the axle is needed as with the original part.

Tamiya Dyna Blaster part H4

Part H3 for the original Tamiya Dyna Blaster RC car.

Drill the small holes to 2.5mm and tap with M3 threads.

Drill the large center hole to ~6mm to fit the axle. Drill the space for the bearings to ~8mm.

The spacer washer under the axle is needed as with the original part.

Tamiya Dyna Blaster part H3

Part H3 for the original Tamiya Dyna Blaster RC car.

Drill the small holes to 2.5mm and tap with M3 threads.

Drill the large center hole to ~6mm to fit the axle. Drill the space for the bearings to ~8mm.

The spacer washer under the axle is needes as with the original part.

Part H2 (and H1, if mirrored) for the Tamiya Dyna Blaster RC car.

The model constains the spacer part B2, which was separate in the original.

You'll need to drill out the axle holes to 3mm and to tap the ball joint mounting hole with an M3 thread.

This was designed for and tested on an original Dyna Blaster. My understanding is that the original and re-make Dyna Storm also use the same part.

Tamiya Dyna Blaster part H2

Replacement part D2 (also D1, when mirrored) for Tamiya Dyna Blaster RC car.

Instead of captive nuts inside the part as with the original, use washers and external nuts for mounting. You'll also need slightly longer screws than the original ones for this.

You'll need to drill out the mounting holes to 3mm to fit the screws. The hole for the wheel arm needs to be drilled to 4.5mm to fit the original oil copper bushings.

Designed for and tested on an original Dyna Blaster. My understanding is that the original Dyna Storm and the later re-make of the Dyna Storm also use the same part.

Tamiya Dyna Blaster part D2

Replacement part D2 (also D1, when mirrored) for Tamiya Dyna Blaster RC car.

Designed for and tested on an original Dyna Blaster. My understanding is that the original Dyna Storm and the later re-make of the Dyna Storm also use the same part.

Unskilled regarding most things. Trying to change that.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

ahhuhtal

SVI-2000 robot gripper finger

Tamiya Dyna Blaster part H4

Tamiya Dyna Blaster part H3

Tamiya Dyna Blaster part H2

Tamiya Dyna Blaster part D2