Extruder cover for a Sidewinder X1 with an arm to have a Raspberry Pi Camera pointed at the hotend with holders for the ribbon cable

Sidewinder X1 Extruder cover with arm for RPi camera

Sidewinder_ExtruderCover_w_CamArm_V0.2.1.stl

Right X-Axis Cover with a mount for a Raspberry Pi 4 and an arm for a RPi4 camera ribbon cable.

RPi4 Mount for Sidewinder X1 right X-Axis Cover

RPi-Mount_V1.2.stl

A case for a USB-Stick that looks like the CPU from a T 800 Terminator. Lower part

T800 CPU Chip USB Case

A case for a USB-Stick that looks like the CPU from a T 800 Terminator.

T800-CPU Chip v2bN bottom.stl

I use a magnet stirrer for cleaning my Resin prints, but somehow the IPA couldn't quite flow. So I created a little helper.
Place the lower part into the glass, put the printed parts on the upper part and place the upper part on the lower part in the glass. Switch the magnet stirrer on and clean your parts.

 

I designed the helper in two parts. a lower part that stays in the glass and makes the IPA circulate and a upper part to put the prints on. There are two vrsions of the upper part. One with 10mm spikes and another with 20mm spikes.

Magnet Stirrer Helper

The upper part with 20mm long spikes for bigger and flat prints.

MagnetCleanerEinsatz-V2-TOP-20mmSpikes.stl

I needed a fancy case for my Raspberry Pi so I remixed the GNK Power Droid from TanRu for either a Raspberry Pi 3 or 4.

I cleaned the original stl-File, split it into six parts for better printing, hollowed it and enlarged it so a Raspberry Pi will fit inside. I wasn't sure if I put a RPi3 or 4 inside, so I built a bottom part for each model. The print is made from six parts. The legs, the bottom lid, the bottom part (with mounts for a RPi), the top lid, the top and a baseplate, because the print is a bit top-heavy. I added a 5,5mm hole for a power/activity LED in the front, a hole for a power button and a mount for a 40mm fan on the top lid. The top half works for the RPi3 as well as for the RPi4 version.

I found out that printing version 1 of the body parts needed a lot support material. So I created for the RPi 4 body a version optimized for better printing. And I still work on making the parts better printable. Suggestions are welcome.

GNK Power Droid Raspberry Pi 4 Case

Baseplate 100x100x33.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

XPlusE

Achievements

Seedling

Sidewinder X1 Extruder cover with arm for RPi camera

RPi4 Mount for Sidewinder X1 right X-Axis Cover

T800 CPU Chip USB Case

Magnet Stirrer Helper

GNK Power Droid Raspberry Pi 4 Case