This part is to repair the Clamp Head for the Parkside Mini Squeeze Clamps (Will probably fit other brands too as long as they are the mini sized ones).
You need to reuse the Bolt, Nut and Soft Clamp Pad from the original part. You may need to use a small file to clean up inside the bar hole and pad slots depending on how good your bridging is. Also I used a thin saw to cut a slot down the back of the head vertically to just below the bolt to allow it to clamp onto the bar which is the same as the original works but this may not be necessary.
Destruction tested one and it deformed but wouldn't break so seems to be a lot stronger than the original.
I printed in PETG 5 walls 10 Top and bottom layers 20% Gyroid Infill Tree Supports on base only Placed on side with nut insert up
NOTE: This is for the MINI size clamps with 3mm thick bar. I have included the STEP file so if you have the bigger clamp you may be able to scale and adjust it to fit but I haven't tried.