INFO I have created a Bolt-Lock version of this model here for those that are interested.

I searched for screwdriver holders but almost everyone I found required me to insert the screwdriver into a hole in a ledge. I wanted something that just allowed me to "grab & pull" the screwdriver off the Multiboard. The closet I found to what I wanted was from @Stranula on Printables.

This gave me the incentive to try my own thing out and here is what I have created so far:

• Single Pushfit small
• Single Pushfit regular
• 6-Up Pushfit rail for small screwdrivers
• 6-Up Pushfit rail for 3 small and 3 regular

The small clip will take a screwdriver with a shaft diameter of 2.5-4mm The regular will take a screwdriver with a shaft diameter of 3-6mm

I have printed them using Basic PLA and they seem to stand up well to multiple removal/insertions without loosing their springiness, but only time will tell :-) It was my first attempt in FreeCAD of using b-splines and creating a spring effect so I learnt a lot while trying to create these clips.

I printed using standard settings, only changing to 3 wall loops.