This is a HueForge image of Bruce Lee from Enter The Dragon. Printed on the Bambu Lab P1S.
The colors used in this print are basically Black, Grey, Beige, and White. Slicing instructions and color change locations are listed below.
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
Filaments Used: - PLA PolyTerra Charcoal Black Transmission Distance: 0.3 - PLA Paramount 3D Castle Limestone Gray Transmission Distance: 3 - PLA BambuLab Basic Beige Transmission Distance: 8 - PLA+ Sunlu White Transmission Distance: 5
Swap Instructions: - Start with Charcoal Black - At layer #18 (0.84mm) swap to Castle Limestone Gray - At layer #24 (1.08mm) swap to Beige - At layer #36 (1.56mm) swap to White for the rest.
Hope you enjoy it.