U

Retro Rocket Piggy Bank

by
UliLac
Follow
Follow
Remix Model
U
UliLac
|
Image 1 of 2
Retro Rocket Piggy Bank 3d model
U
UliLac
|
Image 1 of 2
Retro Rocket Piggy Bank 3d model
2D
3D
Makes
Retro Rocket Piggy Bank 3d model
Retro Rocket Piggy Bank 3d model

Just another Retro Rocket Piggy Bank - the concept makes it a remix (from https://www.thingiverse.com/thing:689004 and https://www.thingiverse.com/thing:2714573) but it is an original design from scratch. Anyways.

Different from the orignal designs the closure went to where it belongs (bottom), plus I added some decorative rivets along the rocket body and some additional jets on the tail fins - mainly to give it some surface to stand on while printing.

The Lid (two variations) prints without supports, the rocket body however needs some - but remember to put a support block on the nose and well beneath, otherwise you end up with supports inside the rocket body - and you do not want that.

The model prints just over 20 cm high, to the delight of the future owner of your model the coin slot will accept Swiss 5-Franc coins (and, of course, bills ...)

Enjoy


14 Likes59 DownloadsDecember 15, 2021


14 Likes59 DownloadsDecember 15, 2021