Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:2869073.

This is a TF2 logo keychain based on the r/place logo created on Reddit. To get the multi colour I used the 'Change Filament at Z' Cura plugin. (https://www.thingiverse.com/thing:2077884)

My printer settings were 0.2mm layer height, 0.24mm layer width. The layer count used to change filament is as follows: 0 - Black 6 - White 8 - White 10 - Orange 13 - Yellow 16 - White

You can check and use different layers in your slicer and update the colors accordingly.

Use infill greater than 40% to get good surface finish.

Feel free to use this however please give proper credit.